For any instrumentation, in the purchase and installation process must pay attention to the installation steps and related matters, theSpeed ReducerFactory editorial from the following three points want to analyze with you how to use safely.
1, prohibited hammering: the output shaft of the reducer, couplings, pulleys, sprockets and other couplings can not be used to directly hammer the method, because the output shaft of the reducer structure can not withstand axial hammering, can be used to screw holes at the end of the shaft screws into the pressure into the coupling parts.
2, be sure to install the vent cap: before use should be the highest position of the plug for the exhaust screw plug, to ensure that the speed reducer running when the gas out of the body. If not replaced in time, the reducer runs for a long time, and the gas in the reducer will cause the oil seal to swell, so that the reducer leaks oil.
3, timely replacement of reducer lubricant, pay special attention to the first time: special attention should be paid to the first oil change, reducer in the first run 300 ~ 400 hours should be replaced in a timely manner after the lubricant, and then every 1,500 ~ 2,000 hours to replace the lubricant. In addition, in the harsh working environment, high temperature, dusty work occasions should be every half a month on the lubricating oil for a check, found that the lubricant has dirt that is to replace the lubricant, in order to keep the lubricating oil clean, to extend the service life of the reducer, and to improve the economic benefits. Release all the previous lubricant, flush it out, and then rejoin the new lubricant.