Since the chainsawsprocketsThe cutter of the blade is very sharp, to ensure safety, always wear thick protective gloves when installing. The chainsaw guide and chain can be installed correctly by following the 7 steps below:
1, Pull the chainsaw front fender back, make sure the brake is in the released position.
2, loosen and remove the two M8 nuts and remove the right side cover of the chain saw.
3, first of all, the chain saw guide plate mounted on top of the host, and then the chain saw chain mounted on the sprocket and guide plate guide groove, and pay attention to the direction of the chain saw teeth.
4, Properly adjust the tensioning screw located on the outside of the right side cover, referring to the blue line above, so that the tensioning pin aligns with the guide plate pin hole.
5, install the right side cover of the chain saw to the main body, and also the same reference to the blue line, so that the front baffle pin inserted into the box pin hole, and then slightly tighten the two M8 nuts.
6, the left hand lifts the guide plate, the right hand with a screwdriver right screw tensioning screw, properly adjust the chain tension, check the chain tension by hand, when the hand strength reaches 15-20N, the standard distance between the chain and the guide plate is about 2mm.
7, finally tighten the two M8 nuts, and then use both hands (wearing gloves) to rotate the chain, check the chain transmission is smooth that is, the adjustment is complete; if not smooth first check the reasons, and then re-adjusted according to the above order; Kremp guide plate Kremp chain